|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-25-2008, 03:03 PM
|
#1 |
|
Senior Member
Join Date: Dec 2005
Location: TN
Posts: 2,448
|
Painless Wiring and Welder Series Gen III parts
http://www.welderseries.com/
Got a set of LS-mounts to put a 4.8 in my '47 IH (sitting on a 65 C-10 frame) and they were awesome. I used my truck mounts, had to trim them a little but did retain the truck mounts, they costs 60.00 for the set and worked and looked great! A+ service also. Purchased a Painless 4.8/5.3/6.0 harness and it was the best wiring harness I have ever installed! Great instructions, took about two hours to complete! Plus, since I got the harness, they flash te Vats and EGR stuff out for free! TWO GREAT COMPANIES TO WORK WITH. A+ Money well spent!
__________________
1947 International KB-1 1957 Chevy Bel-Air riding low 1962 swb fleetside 2002 Chevrolet Silverado 7-inch lift on 35 Daily driver 2016 Chevy Tahoe Better halves ride |
|
|
|
11-26-2008, 09:51 AM
|
#2 |
|
Registered User
Join Date: Nov 2008
Location: Breslau, Ontario
Posts: 2
|
Re: Painless Wiring and Welder Series Gen III parts
This just came to my attention, and I wanted to jump on and say thanks for the kind words.
|
|
|
|
|
11-26-2008, 10:30 AM
|
#3 |
|
Senior Member
Join Date: Dec 2005
Location: TN
Posts: 2,448
|
Re: Painless Wiring and Welder Series Gen III parts
No problem, tell Paul that Josh at Buckaroo said thanks!
__________________
1947 International KB-1 1957 Chevy Bel-Air riding low 1962 swb fleetside 2002 Chevrolet Silverado 7-inch lift on 35 Daily driver 2016 Chevy Tahoe Better halves ride |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
