|
05-11-2004, 01:10 PM
|
#1 |
|
Registered User
Join Date: Mar 2004
Location: Alabama
Posts: 705
|
Blazer in Alabama
'71 Blazer belongs to a friend of mine, took these when I delivered him some new parts. Pictures were from late in the day and I had to lighten them some, so color may vary a little. I picked up several parts from Tim Christian at the SCS in Memphis and a few more from him at the truck nats show a few weeks ago. Only got the 4pc Lock set installed for the pictures. Will take a few more next time, hopefully with a few more of the new parts, and a little sun.
|
|
|
|
05-11-2004, 01:11 PM
|
#2 |
|
Registered User
Join Date: Mar 2004
Location: Alabama
Posts: 705
|
two more pictures
|
|
|
|
|
05-11-2004, 01:15 PM
|
#3 |
|
Registered User
Join Date: Mar 2004
Location: Alabama
Posts: 705
|
last two pictures
|
|
|
|
|
05-11-2004, 03:45 PM
|
#4 |
|
go cyclones
Join Date: Jun 2003
Location: Ames, IA
Posts: 1,885
|
very nice what are the door edge guards? and I take it that the roll bar is not factory
|
|
|
|
|
05-11-2004, 04:27 PM
|
#5 |
|
Registered User
Join Date: Mar 2004
Location: Alabama
Posts: 705
|
Door edge guards are the metal strip that caps the door edge. Either SS or Chrome not sure. Normally on Higher end trucks. Can see a little of it in this pic, but still not real good. Will try to get a close up next time.
|
|
|
|
|
05-11-2004, 05:15 PM
|
#6 |
|
Post Whore
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,683
|
Nice Blazer!
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
05-12-2004, 03:15 AM
|
#7 |
|
Senior Member
 
Join Date: Dec 1999
Location: TN/VA
Posts: 6,388
|
Hey Shan, That Blazer looks Great!!!!!!!
|
|
|
|
|
05-12-2004, 07:53 AM
|
#8 |
|
Registered User
Join Date: Jan 2003
Location: Washington State
Posts: 8,834
|
Super looking Blazer, wish I had that in a 2wd...
__________________
1970 Chev CST 2003 Harley Fatboy 1975 Chevrolet Step Van 1956 Chev Bel Air 1977 Blazer 2WD For Sale $3000.00 1978 Blazer 2WD For Sale $7000.00 1978 Silverado 2005 Monte Carlo |
|
|
|
|
05-12-2004, 10:11 AM
|
#9 |
|
Registered User
Join Date: Mar 2004
Location: Alabama
Posts: 705
|
JayDub
Not sure about the roll bar, was one it when he got it. Smaller bar is part of the soft top supports. Here are a few pics of the edge guards from one of mine. Would say they are SS. Back photo shows the cut out for the lower body line. Tim. Should look better once he or I get those new parts on. He's got a lot going on right now, and I put the lock set in for him. But then I had the keys so I got to go for a test drive... Blue. He was wanting a two wheel, but found this one and seems to like it. It is still at what I think is the stock height so it's not to bad. Will pass on the comments. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
