1990 GMC crew cab build

[jdb_us1]

Originally Posted by jdb_us1

So I replaced the clutch slave and master a few times and its still not right but getting closer. Just keep bleeding. just keep bleeding.

I have been tinkering with upholstery lately and my brother in law gave me a bench seat out of an 03 Dodge. I sat on it in the garage for awhile then had a hair brained idea.

Surprisingly enough it fits in the crew VERY well. The mounting points were only a few inches off of original mounting holes and all but the middle two mounts contact the floor at an angle that does not require cutting and welding.

I have seen plenty of people modify the newer (2000+) GM seats and pancake the floor pans or chop up the seat track. This one dropped right in.

It will need a tilt column but otherwise is fits incredibly well.

Posted via Mobile Device

[jdb_us1]

Not sure what happened in that last post.

2003 Dodge seat installed. Fits very well and six of the eight mounting points sat flat on the floor. Definitely need a tilt column though, its a big snug squeezing between the wheel and the seat.

[jdb_us1]

So after two years of sitting outside, replacing clutch master and slave cylinders and not being able to get them bled, truck has moved into the garage. Found a drivers bed side, on the hunt for a passenger side. Tailgate got media blasted and is at the body shop. Time to get this thing back on the road. Pics to follow as progress occurs.