Rusty 68 K20 Burb

[cablackone]

Originally Posted by cablackone

Firewall to front edge of core support in center is 39 3/8. Same above headlights 39 3/8

firewall to radiator support

[Jsfucttruck]

Here is where I am measuring from. If that measurement is on the $ then I am close.

[Jsfucttruck]

So the gas tank might be able to move slightly forward. The front body mount has room to go forward just enough. I got to lift off the body again to remove the stock 78 K20 Driver rear shock mount that is mounted to the top of my frame. It is in the way of a crossbar.

[Jsfucttruck]

Fuel filler is on the opposite side too. Not sure what I am going to do about that. Might just hack up a 81-91 burb filler door setup.

[cablackone]

Originally Posted by Jsfucttruck

Here is where I am measuring from. If that measurement is on the $ then I am close.

You are about 4 inches to far forward.... with your core support

[Jsfucttruck]

Originally Posted by cablackone

You are about 4 inches to far forward.... with your core support

Are you measuring the same spot?

[cablackone]

I measured from the top of firewall by the seal

[Jsfucttruck]

I almost had to do this.

[Jsfucttruck]

So the neighbor was out of town and let me get a few more measurements. Looks like I am 5" off the mark, and my core support will have to come up too. This puts the front body mount in the way of the upper shackle. I might have to swap in the 52" springs and move the eye hole back sooner than later.