Rat repair.

[swamp rat]

Naturally I order the horn button and mount kit through Grant, and a week later I get the infamous Back ordered email reply.. Well truth is its been pretty darned hot and my truck and cover takes full brunt of the sun so I don't mind letting it sit for a while.

I did take the time to search more and I found my tac dash bezel, relieved to find it.

I also dug out my Aries step bars that were buried, hope to spend a couple early weekend mornings getting them mounted soon, unless I'm asked to work the weekend...

[DD1]

Originally Posted by swamp rat

Naturally I order the horn button and mount kit through Grant, and a week later I get the infamous Back ordered email reply.. Well truth is its been pretty darned hot and my truck and cover takes full brunt of the sun so I don't mind letting it sit for a while.

I did take the time to search more and I found my tac dash bezel, relieved to find it.

I also dug out my Aries step bars that were buried, hope to spend a couple early weekend mornings getting them mounted soon, unless I'm asked to work the weekend...

Glad you found the Bezel! We knew it had to be somewhere. I'm curious, was it somewhere easy that you should have looked sooner, or was it buried in a deep, dark place?

[swamp rat]

Originally Posted by DD1

Glad you found the Bezel! We knew it had to be somewhere. I'm curious, was it somewhere easy that you should have looked sooner, or was it buried in a deep, dark place?

Buried......

[swamp rat]

I’m reading the instructions for my used grant wheel mount kit, it states if my part looks like this picture then I need to remove the stock spring and plunger. Am I to assume I need to bend the brass tabs and remove the brass piece off the back side to get the plunger and spring out?? I’m a bit concerned about the tabs breaking and rendering the part useless.