|
02-03-2019, 02:44 PM
|
#1 |
|
Junior Member
 Join Date: Jun 2018
Location: pleasanton. ca
Posts: 77
|
Torsion bars
Hi guys I am doing a front end rebuild and wonder if anybody has removed the torsion bars from the bottom a arm any help greatly appreciated. 61 c10 complete rebuild front to rear. Thanks Walter
|
|
|
|
02-04-2019, 09:34 PM
|
#2 |
|
Registered User
Join Date: Jan 2013
Location: Las Vegas, NV
Posts: 1,851
|
Re: Torsion bars
Lots of penetrate like PB Blaster, WD Penetrate, Kroil. 2lb hammer, big drift pin or like.
__________________
1962 shortbed 408cui small block, TKO 600 5-speed, bagged Porterbuilt suspension. 18" Salt Flats http://www.cardomain.com/ride/332579...t-c-k-pick-up/ http://67-72chevytrucks.com/vboard/s...d.php?t=560081 |
|
|
|
|
02-04-2019, 10:28 PM
|
#3 |
|
Junior Member
Join Date: Jun 2018
Location: pleasanton. ca
Posts: 77
|
Re: Torsion bars
thanks for the info i will try that did you remove them before or after the a arm was removed thanks Walter
|
|
|
|
|
02-04-2019, 11:02 PM
|
#4 |
|
Registered User
Join Date: Jan 2013
Location: Las Vegas, NV
Posts: 1,851
|
Re: Torsion bars
Before a arms. Tire at full droop, jack on pork chop, remove bolt, release pork chop. Punch bar out of arm.
__________________
1962 shortbed 408cui small block, TKO 600 5-speed, bagged Porterbuilt suspension. 18" Salt Flats http://www.cardomain.com/ride/332579...t-c-k-pick-up/ http://67-72chevytrucks.com/vboard/s...d.php?t=560081 |
|
|
|
|
02-05-2019, 12:03 AM
|
#5 |
|
Junior Member
Join Date: Jun 2018
Location: pleasanton. ca
Posts: 77
|
Re: Torsion bars
Thanks will go at it tomorrow.
|
|
|
|
|
05-04-2019, 07:18 PM
|
#6 |
|
Registered User
Join Date: Apr 2007
Location: GRAND PRAIRIE TX
Posts: 112
|
Re: Torsion bars
Did you get the bars out of the A arm?
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
