Re: What did you do to your truck today part IV
 

Replaced the turn signal switch on my '66 C20

Re: What did you do to your truck today part IV
 

Fixed my rear LED turn signal/brake lights. Found out last night that I had no turn signal or brake lights when my headlights were on.

Spent 5 hours on them today. Got frustrated. Went to a buddies house.

“Try swapping the two connections around. See what happens”

…..damnit.

Re: What did you do to your truck today part IV
 

Have you replaced your mechanical blinker out for an electric one. If not your LEDs will not work. If you have done that than I would suggest checking all of your grounds.

Re: What did you do to your truck today part IV
 

I can only wish it was still winter. It was 101 here last week.

Re: What did you do to your truck today part IV
 

Yes. It was a screw up on the original builders part. The Tail and Brake wires were switched and I overlooked it.

Everything works fine without the headlights turned on.

Turn them on….and no brake lights or turn signal, but DRL are full brightness. Should have caught it.

Now I have it. Swapped them around and g2g.

Re: What did you do to your truck today part IV
 

Whoa, talk about going to extremes! I have heat in the shop, but no AC.

Re: What did you do to your truck today part IV
 

My Sanity has left the building. The '66 is off to the painters to get the roof painted. It should be done in about a week.

Re: What did you do to your truck today part IV
 

Assembled and installed a Craftec cover on the ‘65. Nice product!

Re: What did you do to your truck today part IV
 

Ooh, I like that. If you could, please start a thread about your installation and experience. That would be great for folks considering purchasing one.

Re: What did you do to your truck today part IV
 

Thanks Christian! Will do; I didn’t take any pictures during the assembly but I will grab some more of the installed product and put together a thread.

Re: What did you do to your truck today part IV
 

Bought fender emblems, and installed a new thermostat. Cant get the truck to run over 140*, so purchased another thermostat to try.

Re: What did you do to your truck today part IV
 

Where do you have the sensor for the water temperature gauge installed in the engine? When I first installed my electric fan, I installed the thermostat for it in the back side of the intake manifold on my 350. The fan never turned on because it was not getting hot enough because it wasn’t making contact with water. So I moved it to the thermostat housing and it started getting a proper reading. All that to say, maybe your gauge is not getting a proper reading.

Front of the intake just next to the thermostat housing. Edelbrock RPM intake
Posted via Mobile Device

Re: What did you do to your truck today part IV
 

Ok, yah, that’s where I have mine also. It was just a thought.

Re: What did you do to your truck today part IV
 

What AM I going to do today?

Drill holes in my upper fender shroud things to mount the emblems…..gotta talk myself into it though.

Re: What did you do to your truck today part IV
 

Took my latest project in for front end alignment, all good to a point, all systems functioning, brakes bedded, clutch a bit stiff, will take some getting used to or adjust later, corners like a go cart, only glitch, 78k mile transmission seal decided it want to leak….easy fix, new seal will be here tomorrow…

Re: What did you do to your truck today part IV
 

Looks great Mike!

Re: What did you do to your truck today part IV
 

Went and got it from storage! Started right up, great drive on country roads home.

Re: What did you do to your truck today part IV
 

Great feeling. There should be a song about that.

Re: What did you do to your truck today part IV
 

Cleaned up the taillight connections.
Lights are a lot brighter now.
Had to use PB Blaster to get the old bulbs out.

Re: What did you do to your truck today part IV
 

Tried out a set of flowmaster super 44's. She's stinkin loud haha

https://flic.kr/p/2njDQJ8

Re: What did you do to your truck today part IV
 

Nice TJ!

Re: What did you do to your truck today part IV
 

Sounds Awesome! :)

Re: What did you do to your truck today part IV
 

Sounds great TJ! Looks great too! Glad to see I am not the only one that uses Spray Max 2K clear coat in a rattle can! :)

Re: What did you do to your truck today part IV
 

Sounds pretty rowdy. Not what I would expect a straight 6 to sound like.