Originally Posted by richard2717 (Post 7754981)

here is the last pc I pulled off before the scrap man pulled away. This was under the plywood floor for the rear (3rd) seat. The 2nd row bracket was not worth pulling out. mainly surface rust & I will run a tap thru the threads in the morning to make sure all is well there.

I will give 1968 K20 1st refusal since i am not sure if this is what he was asking for in an earlier post or if it was the brackets attached to the seats.

This pc is $50 shipped due to the weight and length


.

Originally Posted by notchbackgta (Post 7762122)

Is this still available?

Originally Posted by notchbackgta (Post 7762139)

That is under the wood floor ~above the gas tank, right?

Originally Posted by notchbackgta (Post 7762516)

Cool, I'll take it you're taking paypal

Originally Posted by richard2717 (Post 7761855)

Here is a closeup of the struts for Irving. The one still has a tab in the lock/ unlock cut out, the other does not. It did not appear to have any affect on the function of the struts. They will both need some white lube to free them up as they are both stiff.

Originally Posted by irving (Post 7763032)

Pmt sent. Thanks!

Originally Posted by notchbackgta (Post 7762516)

Cool, I'll take it you're taking paypal

Originally Posted by richard2717 (Post 7763070)

Got your payment. Will send out tomorrow and pm tracking.
FYI I ran a tap thru all four welded nuts so the threads are good and clean.

Thanks
Richard

Originally Posted by notchbackgta (Post 7763142)

Sweet, thanks. I will probably blast it and epoxy prime it anyway.

How is it held in? I haven't looked at mine much, I just know some PO put a ragged hole in it to get to the sender through the floor

Originally Posted by Jestradaiam620 (Post 7787699)

How much for the doors?

Originally Posted by Jestradaiam620 (Post 7787945)

Richard,
In what kind of shape are the front door window frames? Have doors need to convert them into square instead of pick up truck rounded frames

Originally Posted by Heliarcn (Post 7793991)

Richard,

I need a couple of short sections of the front frame rails if your willing to cut. Please let me know. Thanks.

Bret

Originally Posted by richard2717 (Post 7793996)

Bret
I already junked all of that and it was in bad shape. I have some other frame cuts here but not sure what you are needing. Post a pic of what you need and I can let you know if I have it.

Richard

Originally Posted by richard2717 (Post 7794046)

It has been raining here all morning. If I catch a break in the rain I will go out and check. Is there a difference in 2wd vs 4wd frames, or are they the same?

thanks
Richard