4l60e cooler line fittings
What is the best sealing washer to use? Been having trouble not crushing the Nylon type and was wondering if the brass washers would work better?
|
Re: 4l60e cooler line fittings
Copper is good
|
Re: 4l60e cooler line fittings
I used an fittings that had platic washers been in there 3 years havent leaked a drop
|
Re: 4l60e cooler line fittings
Im sure you’ve might have already made your mind up on what set up to use.
Here is my 2¢. I initially went with the AN fittings and nylon washers. That only lasted me about 2K miles before I sprung a leak. I went with the original GM fittings at the case that use the C-Clip lock thinks and then use 98-02 Camaro Camaro hardlines. I made a few tweaks to the hardlines, nothing crazy. I ran the hardlines till the reached, let’s say the crank pulley. I cut them off and used Earls hardline to AN compression fittings. From there I ran some fabbed up hoses to my front mounted trans cooler. |
All times are GMT -4. The time now is 12:45 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com