I need a 350 intake gasket
I have a stock 75 L-48 engine with a performer intake with a cross over. Fel-pro has way too many options. I find one and then scroll down to the comments and it says to a buyer your better off with this part #. Go to that part # and says to that buyer your better off with this part #. So I think I have 3 choices. Part # 1256 or #1204 or MS90314-2
|
Re: I need a 350 intake gasket
Three different gaskets for three different applications. 1204 has the exhaust crossover passage blocked. 1256 has crossover passage restricted. MS90314-2 has open passage with the option to install restrictor plates.
Which gasket you need is dependent on whether your heat riser valve is fully functional and if the Thermac system on the air filter housing is in place and fully functional. All of these parts/systems, including the intake gasket configuration aid in cold weather driving during engine warm-up.. |
Re: I need a 350 intake gasket
thank you . Too many choices now, Jeez. Trouble is there isn,t any good partsmen or ladies left. They just know how to order parts.
|
Re: I need a 350 intake gasket
Quote:
|
Re: I need a 350 intake gasket
Ok ,options is the word I,m looking for I guess. Anyway thanks to clear that up for me
|
Re: I need a 350 intake gasket
Quote:
|
Re: I need a 350 intake gasket
OK... I did a comprehensive search on the FelPro website. You didn't give much information on the engine in your truck but based on what you did provide, the gasket set you need is Part # MS90314-2.. Now, you have to figure out if the restrictor plates are needed for the heat riser passage.. I suggest you refer to the Factory Service Manual for the configuring of those plates.
|
Re: I need a 350 intake gasket
It,s a stock L-48 That the gasket I bought yesterday. Again thanks
|
Re: I need a 350 intake gasket
I like that heat passage blocked. It always burns the heck outta the paint on the intake when it's not and I don't really drive my old truck around doing a lot of stop and go in cold weather anyway.
|
Re: I need a 350 intake gasket
I did a search on crossover, lots of some do and some don,t. Enough to give you a headache
|
Re: I need a 350 intake gasket
The 1204 is steel core laminate and is not recommended for use with aluminum intakes.
https://www.summitracing.com/parts/edl-7201 |
Re: I need a 350 intake gasket
Quote:
|
Re: I need a 350 intake gasket
Quote:
|
Re: I need a 350 intake gasket
1 Attachment(s)
Quote:
From Edelbrock's website. |
All times are GMT -4. The time now is 10:40 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com