Battery Tray Rebuild
4 Attachment(s)
The original battery tray in my truck had some rust holes in the center plate that the battery sits on. I found a NOS replacement plate #15615763. I drilled out the spot welds and then welded the parts back together. I also added an A/C bracket (provided by member 1968C30) since I'm planning on adding A/C soon.
I center-punched all of the spot welds and then drilled them out first with a 1/8" bit and then 1/4" |
Re: Battery Tray Rebuild
5 Attachment(s)
I cleaned up the side brackets with a wire wheel. I clamped the side brackets to the top plate with Vise Grips and then welded the components back together by filling the drilled holes. After attaching one side bracket, I installed the partial assembly in the engine bay temporarily to determine the best alignment front-to-back for the other bracket. It turned out that the best was with the large holes that are both in the top plate and the side brackets aligned. One set of these holes was not well-aligned originally.
|
Re: Battery Tray Rebuild
4 Attachment(s)
I ground the welds flat on the side of the inner bracket that will be visible when installed in the engine bay. I also ground the welds flat on the underside where the A/C bracket would go. I then welded on the A/C bracket. I used the remnant scrap piece of the donor battery tray that was previously attached to the A/C bracket as a guide for positioning the bracket.
|
Re: Battery Tray Rebuild
2 Attachment(s)
The last step, of course, was to prime and paint it. I will give it a few days to dry before reinstalling it in my truck.
|
Re: Battery Tray Rebuild
Oooo Weee! That looks like some damn fine work. Kudos!
|
Re: Battery Tray Rebuild
yeah its the bottom of the PS fender that takes a punch from battery acid...so the tray itself gets beat up also
Nice job OP |
Re: Battery Tray Rebuild
Nicely done.
|
Re: Battery Tray Rebuild
great work.looking very nice.
|
Re: Battery Tray Rebuild
Very well done, congrats!
|
Re: Battery Tray Rebuild
1 Attachment(s)
Thanks, guys.
Quote:
|
Re: Battery Tray Rebuild
Very nice! I did similar to a '73 this year. Very satisfying to see it back and holding the battery in instead of wood and bungies.
|
Re: Battery Tray Rebuild
Quote:
|
Re: Battery Tray Rebuild
Love it. Nice attention to detail, and who could argue with those results!
:metal: |
Re: Battery Tray Rebuild
2 Attachment(s)
Reinstalled. The heater core return hose interferes with the A/C bracket on the battery tray, so I will need to replace it with a longer hose.
|
Re: Battery Tray Rebuild
Nice job on your repair. I was not so lucky. My box was rotted out along with my inner fender and core support. So I made a box and moves it to the frame rail.
|
All times are GMT -4. The time now is 09:00 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com