The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   door striker pic request (https://67-72chevytrucks.com/vboard/showthread.php?t=821256)

blazer2007 04-30-2021 09:10 AM
door striker pic request
 
I have to fix my rotten door striker mounting section on door frame but can,t find a pic of stock door frame to see how big the hole is for the striker for adjustment . Is on a 78 blazer

blazer2007 05-01-2021 09:08 AM
Re: door striker pic request
 
1 Attachment(s)
this what i have, I trimmed out for the new patch but I know where the striker goes is a larger hole but I don,t how big it is. I do have the threaded block for it, it is out for now

mongocanfly 05-01-2021 09:28 AM
Re: door striker pic request
 
Can you not measure off the drivers side?..

Pontiac1976 05-01-2021 08:53 PM
Re: door striker pic request
 
Well as mongocanfly has said. Because you should take a look at it. Because the square if I recall right it moves in side about a 1/4" all around for Adjustment’s of the striker to line up the door. And the big washer covers the hole ( so the hole smaller then the washer but bigger then the bolt) I would put your hand behind feel how it finished there.


Ho just the square is open just remembered

blazer2007 05-01-2021 09:12 PM
Re: door striker pic request
 
Well stupid me , the striker bolt will only slide around the sq. hole inside, so the new plate will have to have the same sq. hole which is 3/4x3/4 . Match new plate up and center and weld it up. Over thinking that one .

Getter-Done 05-01-2021 10:48 PM
Re: door striker pic request
 
Quote:
Originally Posted by blazer2007 (Post 8915773)
Well stupid me , the striker bolt will only slide around the sq. hole inside, so the new plate will have to have the same sq. hole which is 3/4x3/4 . Match new plate up and center and weld it up. Over thinking that one .
At least you are going to fix it:metal:

So try not to beat yourself Up:sumo:

I was going to take measurement from a scrap cab I have.

Then mongocanfly came to the rescue:metal:


You can do this.







.


All times are GMT -4. The time now is 08:49 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com