Truck door cut down question
1 Attachment(s)
I'm familiar with Big J's post detailing the truck door conversion.
http://67-72chevytrucks.com/vboard/s...d.php?t=273729 However, I'm wondering if anyone might have these measurements (see photo below). I took some photos in the junkyard a few years ago, but like an idiot, didn't measure anything. The doors were rotted out and reinforcement parts already removed so I didn't buy them. To make the angled cut easier, I'm trying to find out what the measurements are where I have the two red arrows. From the outer door edge to rear of angled cut, and inner door edge back to where front of angled cut ends. Hope that makes sense, pictures explain it better. Thanks. |
Re: Truck door cut down question
They are in the assembly manual, I can grab you a picture tomorrow afternoon.
|
Re: Truck door cut down question
A third measurement of how far back the left line is from a forward reference point might help also
|
Re: Truck door cut down question
I ran out of time today, I'll get it tomorrow afternoon.
|
Re: Truck door cut down question
4 Attachment(s)
Here you go
|
Re: Truck door cut down question
Quote:
|
All times are GMT -4. The time now is 09:53 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com