engine speed sensor/ crank sensor wiring for tachometer 97-98 sensor
 

I installed a 97-98 engine speed sensor/ crank sensor to run my tachometer. I have already ran a 5 volt power, ground and sender wire for it but I can't find the pin out.

here is a pic of the plugs the one with the 123 is the harness side the the other in the sensor.

https://easyautodiagnostics.com/imag...23/image_4.jpg

I need to know where the power, ground and sender wires go on the 123 plug.


Here is a pic of the sender I am using.

https://www.genosgarage.com/images/u..._274_popup.jpg

Re: engine speed sensor/ crank sensor wiring for tachometer 97-98 sensor
 

I just went through this a couple years ago when I did a 6.4 12v swap. I'll see if I can find the info again.

On edit, I found it. It was in the instructions for the swap helper tach box I used. Sorry the image is side ways.

1 is 5 volt supply
2 is Sensor ground
3 is Crankshaft position sensor signal

Re: engine speed sensor/ crank sensor wiring for tachometer 97-98 sensor
 

Thank you!