Gas Guage Prob's
I have a 78/79 k10, A 1/2 ton lwb. I had to buy a new gas tank and also got a new sending unit, got it in n wired up good... But my gas guage won't go below a half a tank. This is my 2nd guage as my first one wouldn't sit still, it just bounced from E to F every time i hit a bump. Is my 2nd guage bad as well? I'm going to run after market guages in my bezel but until then i need a good one. Do any aftermarket's (prefferbly equies so it matches) make a guage that will work woth our sending units? Thanks
Posted via Mobile Device |
Re: Gas Guage Prob's
all the wires making good contact?
clean maybe the terminals where the gauge prongs go into maybe check behing your cluster for a lose ground or loose sender wire my gauge bounces too when i hit a bump, when my tank is full it dosent bounce but once it has a few gallons out, the gas sloshes and gives a false reading you can check your gauge with 2 C batterys |
Re: Gas Guage Prob's
I had the same problem with my square. I tracked down the wiring and found a spot where the insulation had worn off and would ground to the frame whenever I hit a bump or rough road. My problem was where the wire ran along the inside of the frame, right below the passenger side door. Electrical tape can be a life saver.
|
Re: Gas Guage Prob's
Bouncing is normal in an air core meter. It can be mitigated somewhat with an injection of some special silicone damping gel. Gauge repair guys can do this for you pretty quick.
Not dropping below 1/2 tank indicates increased resistance somewhere in the circuit. Is the ground wire from the sender to the frame making good contact? You can bench test a fuel gauge with a charged 12v battery, 4 alligator clip test leads, and a couple 1/2W resistors (100ohm and 50ohm 90 & 45 would be better but 100 & 50 are close enough). It's worth noting that the resistors can get VERY HOT so be careful of where you place them... not on the kitchen table or those greasy rags. :devil: If your gauge passes these tests it's not the problem.
|
Re: Gas Guage Prob's
my 78 Jimmy bounced
when I changed from idiots to tach and cluster i had to add a seperate ground for the fuel gauge ground it stopped my 79 I was worried changing to a spectra unit this summer it would bounce nope if it's working right, grounding the sender wire is E,off is over F I'd check the tank ground for sure |
Re: Gas Guage Prob's
Posted via Mobile Device
|
Re: Gas Guage Prob's
My fuel gauge bounces on both tanks, always has, I thought it was supposed to do that. :lol:
Posted via Mobile Device |
Re: Gas Guage Prob's
Ill check tonight in the garage and see what happens
Posted via Mobile Device |
All times are GMT -4. The time now is 01:55 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com