Could anyone with an inline 6 help?
Would anyone with a '63-'66 Chevy/GMC truck and an inline 6 take some measurements for me? I am installing a 292 in a '66 GMC with aftermarket frame/engine mounts and want to get it in roughly the factory placement, but the factory crossmember is gone. Even just sharing pictures would help a lot.
1. Distance from front of block to frame cross braces that the radiator sits on. 2. Distances from left and right frame to center of crank snout/harmonic balancer. 3. What degree should the engine be leaning back? These will greatly help me install my 292. Thanks! |
Re: Could anyone with an inline 6 help?
I'll grab some measurements this afternoon and PM you.
|
Re: Could anyone with an inline 6 help?
Quote:
|
All times are GMT -4. The time now is 11:58 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com