The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)

- - 90-91 suburban cluster swap issue (https://67-72chevytrucks.com/vboard/showthread.php?t=821964)

yellowGT

05-20-2021 04:35 PM

90-91 suburban cluster swap issue

So I did the swap and thought it was all good. Then I go to start the truck and the speedo starts acting like a tach. Yes, a tach. I smash the accelerator and the speedo needle moves. This is happening with the vss wire coming from ecm to pin 18 on the cluster plug. What did I do wrong? Mind you that the white tach wire from ecm is not spliced in to anything.
Posted via Mobile Device

wildwilly4x4

05-20-2021 07:22 PM

Re: 90-91 suburban cluster swap issue

is the trans in gear but driveline not installed? Positive and double checked the pin locations? I haven't wired one up myself, but I am in progress on an 8.1 swap in an '84 C10. I have swapped other trucks, but they were all cable drive speedos.

wildwilly4x4

05-20-2021 07:29 PM

Re: 90-91 suburban cluster swap issue

Which PCM are you using?

Green/ Blue connectors show pin 50 on the green connector for electronic speedo (green/ white trace)

Red/Blue connectors pin 50 on the red connector is what should go to the speedo.

All times are GMT -4. The time now is 11:13 AM.