Anyone have experience installing CPP c-nothch kit?
 

I bought CPP's c-notch kit as I am planning on running a 4/6 or 5/7 static drop on my 69 C20 suburban. I was crawling around under the truck today and noticed that there is a body mount bracket right by where the c-notch bracket gets installed. I didn't have the kit with me today but I am wondering if I am going to run into problems with that body mount bracket interfering with the c-notch bracket. Has anyone installed this kit? Did you run into issues? What was yoyr experience?

CPP P/N: CNK6372HD

Re: Anyone have experience installing CPP c-nothch kit?
 

I'm almost certain member Hart_Rod used them in his SuperBurb build. (See build section) His build thread is like 75 pages long so you will have some reading but, his Burban is one of the very finest around so its an easy read.

Correction his old Burban. He sold it awhile back.

Re: Anyone have experience installing CPP c-nothch kit?
 

Dunno if this is any help. Same notches put on my panel. I didn't do them though a board member did all the chassis stuff for me. Not sure if Burb and panel are the same back there.

http://67-72chevytrucks.com/gallery/...0/C--notch.jpg

Re: Anyone have experience installing CPP c-nothch kit?
 

HO455 ‐ Thanks for the lead. I will have to read theu his thread

CG - Thanks for the picture. What I am trying to figure out is how people have handled the body mount bracket that is in the outside of the frame.

Re: Anyone have experience installing CPP c-nothch kit?
 

Just get a good pneumatic air hammer. Mine was a cheapo and I magnetized a few tools by the time I was done. And bruised a few knuckles