Door alignment question
My driver side door is out of alignment, (it hangs low at the rear of the door. The hinges are good and the striker is new). I need to loosen the lower hinge where it bolts to the cab so I can move the door to the rear. My main question is, can this be done without removing the fender or is that the only way? TIA
|
Re: Door alignment question
Yes you can just take the door off.
|
Re: Door alignment question
Quote:
|
Re: Door alignment question
You can do it with the door on, I did. I had taken my doors off to replace the hinge with new ones. Then of course the doors needed adjustments. I was adjusting just about everything. The hinge bolts to the fender, hinge bolts to the door and the striker bolt. I finally got it right. The doors close very nice now, and they the lines look good and flush.
|
Re: Door alignment question
Quote:
|
Re: Door alignment question
Quote:
|
Re: Door alignment question
1 Attachment(s)
With these trucks these wrenches are invaluable. But in SAE
|
Re: Door alignment question
Quote:
|
Re: Door alignment question
Amazon has them
https://www.amazon.com/gp/product/B0...KIKX0DER&psc=1 |
Re: Door alignment question
Wished I would have know about these. I made due, but this could have made the job a bit easier.
|
Re: Door alignment question
Quote:
Quote:
|
Re: Door alignment question
I got them on Amazon but I also have a few box end wrenches I put a vise heated and bent them .
|
All times are GMT -4. The time now is 12:07 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com