Tail light fuel filler
5 Attachment(s)
Here's my version of a tail light fuel filler. I would have taken better pics of it as it went together, but my fab skills leave alot to be desired.:rolleyes: It was fun though, and turned out ok I think. It still needs some fine tuning(rubbing, spring tension, paint, etc), but I'm satisfied so far. Filling the tank will be the real test. Thanks to you guys that helped with ideas and parts.
|
Re: Tail light fuel filler
1 Attachment(s)
Quote:
The LEDs came from ECE, and are manufactured by board member "Jmac05". Other than that, it's just 1 & 1/2" muffler pipe, fuel hose & clamps, some 3/8 pipe fittings, an old hinge that I had, a throttle spring, sheetmetal, bondo, & primer. If I was to do it again, I'd change a few things like lowering it a half inch or so, and I would change the angle of the muffler tubing to aim straight at the tank filler pipe. This would require removing one or two of the bedside to rear crossmember bolts, but I think it would still be strong enough. Oh yeah, the 2 rubber bumpers are 67-72 fleetside tailgate bumpers. Here's another angle. |
Re: Tail light fuel filler
Quote:
Frank (PICKMUP) has changed suppliers, and doesn't sell this brand anymore. |
Re: Tail light fuel filler
1 Attachment(s)
Quote:
EDIT- Well, you can hardly see it, but I circled it with red just under my finger on the left side. |
Re: Tail light fuel filler
Quote:
|
All times are GMT -4. The time now is 12:44 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com