2 piece drive line
 

Beating a dead horse, but I am still not clear on this. Drop member extreme with ls motor, 4l60e trans running to carrier out to rear with stock trailing arms
Ok I know I need to set it at ride height and set trans pointing down to 6 degrees. My rear end it point down towards the carrier bearing. What I have is both shafts running down hill towards the carrier bearing. Is this correct? I know I need to get the exact angles but my drive line looks like a v from trans to diff. Any and all help would be great.

Re: 2 piece drive line
 

6 degrees seems like alot to me? I thought it was 2 to 3 degrees, no more than 3 ?

Re: 2 piece drive line
 

Dan-

Email me and I will follow up with a phone call tomorrow. It's easier to explain in conversation rather than text.

I am working on a little tutorial that should be done shortly.

Nate@pbfab.com

Re: 2 piece drive line
 

Think I found my answer, if this diagram is correct.