'51 fender to cab seal??
guys, my step dad his building a 51 4x4 1 ton truck that he just put a 460 in and the plan is to remove the bed and install a welder type setup. they have well did the fenders to the hood, and are planning on slicing the fenders from about 2 o'clock position on the wheel angle towards the cab. the hood will open towards the front like a Peterbilt. For some reason he needs the seals that he thinks go between the fenders and the cab. I looked on LMC trucks diagram of this model truck and according to them this seal does not exist. Anyways can you guys tell me if this deal can be bought? Or if there is even one there
|
Re: '51 fender to cab seal??
|
Re: '51 fender to cab seal??
15 and 16???
|
Re: '51 fender to cab seal??
15 looks like it doesn't go between the fender and cab.
16 looks like it could be it, but it just shows a roll, it doesn't show where it goes. Anyways he made his own. Thanks |
Re: '51 fender to cab seal??
15 looks like it doesn't go between the fender and cab.
16 looks like it could be it, but it just shows a roll, it doesn't show where it goes. Anyways he made his own. Thanks |
Re: '51 fender to cab seal??
Old school rod guys used to use VWbug fender welting too, came in a variety of colors so paint would not chip off.
|
Re: '51 fender to cab seal??
Quote:
https://www.google.com/search?q=Fend...x-a&channel=sb I'd think LMC would show it, maybe on the rear fenders section. Some guys just had the upholstery guy sew some up too. That would no doubt cost a lot more than ordering or hunting down a roll though. |
All times are GMT -4. The time now is 12:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com