Gringoloco's Camaro tach install
1 Attachment(s)
Played around with the truck a little on Saturday- thought I would show you guys some pics.
This is what I've been staring at since I got the truck- BLAH. There was also a column mounted SunPro tach- very functional, but not the prettiest. |
Re: Gringoloco's Camaro tach install
3 Attachment(s)
I started out by tearing the Camaro tach out of the cluster I bought on eBay and started modfying the truck gauge tin to fit it. You can see here where the back tin must be clearanced for the black plastic insulator to fit through.
|
Re: Gringoloco's Camaro tach install
4 Attachment(s)
Here you can see where I mounted the backing plate from the Camaro cluster to mount the tach to. Also note where the plate had to be trimmed for the right blinker bulb and the area that the dash connector was is flattened out.
The plate is marked for the input and 12V the upper middle stud is the ground. I just ran a nut down it and grounded the tach to the cluster. I ran a wire from the ammeter input to power it and a wire from the distributor for the signal. Dont forget all the plastic insulators on the studs! |
Re: Gringoloco's Camaro tach install
5 Attachment(s)
You can see in the last pic I also replaced the ammeter with a voltmeter. Just personal preference. I used the guts from a $15 SunPro voltmeter. Basically just tore the gauge apart, trimmed the stock face plate to fit, and drilled two holes in the backing plate.
Again, I just grounded the voltmeter to the cluster and used one of the old ammeter leads to power it. Luckily the SunPro bucket is the same depth as the stocker, so it mounts right up |
Re: Gringoloco's Camaro tach install
4 Attachment(s)
Used some metal polish to take the lines off the inside of the tach lens and slapped it back together with a new bezel. I also used a spare fuel gauge needle on the tach so it would look like it belongs.
It all just kinda fell together(with a little trial-and-error) and looks tons better than before. Whatcha think? |
Re: Gringoloco's Camaro tach install
1 Attachment(s)
Quote:
Quote:
Quote:
That's kinda the reason I did this. I thought the FAQ was lacking a little in the details of how to mount the tach- this could maybe be added to it? Quote:
Thanks guys for all the compliments. This really is very easy to do with a little time and a dremel. -Chris |
Re: Gringoloco's Camaro tach install
Quote:
|
Re: Gringoloco's Camaro tach install
2 Attachment(s)
Here's those nighttime pics I promised; anyone notice anything different about the second one?
|
All times are GMT -4. The time now is 08:30 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com