TORGUE CONVERTER questions!!!
i am about ready to bolt up my th350 to my 283 i got the flywheel on. i was curious how to manully turn over the motor to bolt the torgue converter bolts, and which way does the torgue converter bolts go or does it no mater. i just rather no then not no.
any adivce in great. Lukas |
Re: TORGUE CONVERTER questions!!!
I have a flywheel turner now, but for years just used a big screw driver
http://www.summitracing.com/search/d...-turning-tools there are cheaper ones out there, try Harbor Freight |
Re: TORGUE CONVERTER questions!!!
The proper tool is the best way, but it can be done with-out one. In either case, taking the spark plugs out makes it a lot easier.
|
Re: TORGUE CONVERTER questions!!!
I'm about to do the same thing and its my first time. I was told a good way is to put some longer bolts in the three holes in the harmonic balancer and put a big closed end wrench around one and push or pull up against another bolt. Also agree with longhair take the plugs out.
Posted via Mobile Device |
Re: TORGUE CONVERTER questions!!!
I use my hands....doing it slow so the compression bleeds out...
|
Re: TORGUE CONVERTER questions!!!
bump the starter...
|
Re: TORGUE CONVERTER questions!!!
With the balancer off...
http://ak.buy.com/PI/0/300/225084598.jpg With the balancer on (sorry, small pic) http://www.drivewire.com/images/shop...p7566782_1.jpg Then all you need is a 1/2" ratchet to turn it. Gary |
Re: TORGUE CONVERTER questions!!!
flywheel wrench and the convertor bolts go with the nuts to the convertor
|
All times are GMT -4. The time now is 04:26 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com