Djm flip kit
3 Attachment(s)
Just installed a djm flip kit will drop the front in the morning. How many coils should i cut to level the truck out? Thanks in advance. :chevy:
Posted via Mobile Device |
Re: Djm flip kit
As a general rule,... I use this formula:
1/2 coil = 1" of drop. |
Re: Djm flip kit
I also used the DJM flip kit and found that 1/2 coil, along with DJM's 3" spindles, will make it level. Hope that helps.
|
Re: Djm flip kit
I cut off one coil and 3" drop spindles for a slight rake.
|
Re: Djm flip kit
Not to hijack a thread. Can I go 3/4 coil? Any pics? I have a few days off for TG and I think I can do the drop then as I think I'll have my goodies in order.
|
Re: Djm flip kit
Is that the 5" DJM flip kit? Did you need to install c-notches?
|
Re: Djm flip kit
Quote:
|
Re: Djm flip kit
Quote:
how hard/easy was install? no need to take bed off for this kit? |
Re: Djm flip kit
Its the 5" flip kit and i didnt have to take the bed off or c-notch the frame. It was pretty easy. The hardest part was grinding off the old bump stops.
Posted via Mobile Device |
Re: Djm flip kit
Get 3 inch drop spindle and cut a coil
Posted via Mobile Device |
Re: Djm flip kit
is the front lowered at all?
|
Re: Djm flip kit
The front is stock height
Posted via Mobile Device |
Re: Djm flip kit
Quote:
|
All times are GMT -4. The time now is 09:29 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com