Parting 1971 Blazer
 

Before I take the gas axe to this rust bucket I thought I'd do the right thing and see if there is anyone that needs anything off it before it goes to the metal pile. The truck has terminal cancer everywhere and there isn't a ton of sheet metal worth saving. I'm keeping the frame for a future project and partial to the blue interior with utility buckets and rear bench. The hard top is cracked every where and not repairable. Other than that it's up for grabs, cheap. The only issue is I'm busy, very busy and absolutely do not have time to be running around getting shipping quotes. I charge shipping only and do make a run to Montana once a month or so and will ship from there as it's substantially cheaper if you can wait.

Re: Parting 1971 Blazer
 

Interested in stainless strips that hold top down ,carpet strips and carpet leveling mats if it has them and you decide to part out

Re: Parting 1971 Blazer
 

They are rusted through. If by leveling mats you mean the rubber floor mats, they are garbage as well.

Sorry

Dave

Re: Parting 1971 Blazer
 

Interested in the below items if they are worth saving. I can wait till you are in MT to ship. Is there anything under the hood?

- NP205 high hump, stick, knob, boot ring, lower bolt and rod bars
- seat belts - if u r not keeping
- vent window ferrules and screws
- speedo cable
- guage cluster fiber optic cable, indicator and bulb socket
- CB radio and speaker bracket if it's there

Thanks
Jim

Re: Parting 1971 Blazer
 

How is the door glass and the black rubber stopper piece attached to the door between the top and door vertically.
Thanks Carey

Re: Parting 1971 Blazer
 

Are the blue defrost vents and retainer clips intact? If so I will take them, ship to 78602. No rush, I can wait for your trip to Montana.

Re: Parting 1971 Blazer
 

Do you have the plastic door ferrules under the wing windows? 1 in each door... Thank you.

Re: Parting 1971 Blazer
 

Just an FYI if you cut the bucket seat bracket out it is the same as the trucks will sale it quick on the truck side for 60-80 depending on condition plus shipping.

Re: Parting 1971 Blazer
 

I'm interested in the rear seat arm rest bars if they aren't rusted. Also the front and rear brackets that bolt the seat to the floor. Zip is 95982.

Re: Parting 1971 Blazer
 

I'd be interested in the floor brkt that the passenger side seat locks to when it is down.

Re: Parting 1971 Blazer
 

I would be interested in any top to body hold down brackets and hatch hinges.

Re: Parting 1971 Blazer
 

I'm interested on the rear seat complete with brackets if they are not rusted out. Shipped to 92704

Re: Parting 1971 Blazer
 

Interested in radio shipped to 96020 from Montana please! I can wait

Re: Parting 1971 Blazer
 

I need the rear arm rests pads. Also the arm rest bars if they get to me. Let me know a total and I'll get you paid. I can wait on shipping. Thanks, Dustin.

Re: Parting 1971 Blazer
 

OP Last Activity: 07-21-2015 04:13 PM..... Hope he is okay...

Re: Parting 1971 Blazer
 

Looking for blue door arm rests, not in a hurry, let me know if you have them.

Thanks,
Mark

Re: Parting 1971 Blazer
 

are the tail light lens and reverse light lens any good?

Re: Parting 1971 Blazer
 

How are the Rear Seat Seat Belts? If they are decent I will take them pending better picture(s) and price.
Thanks
Justin

Re: Parting 1971 Blazer
 

ill get in line if it gets to me I need

1) mounting hardware and bolts for the top
2) sun visors
3) seat belts front and back with bolts
4) mounting hardware and bolts for the rear seat

id be interested in the top and rear seat too but it would cost way too much to get it to sask

Re: Parting 1971 Blazer
 

Looks as if the OP has forgotten this wonderful Forum.
Last Activity: 08-30-2015 08:44 AM
hope he is okay.

Re: Parting 1971 Blazer
 

rear drum brakes, just the backing plates

Re: Parting 1971 Blazer
 

Hello i would be interested in the driver side seat brackets if picture could be sent and if they are what i am looking for. Price and shipped to 98247 Thanks