Need help with engine mounts/perches
I’m down to just figuring out what mound to run so I can finally drop my LS3 in. I bought some DD sliders and have them on the block now but the POL perches I bought don’t sit flush on the rail of the truck. Reading the instructions I see it says it might need modification to make them work. I don’t want to bend my rails if I don’t need too. I was thinking of getting the CPP and even buying the 73+ style.
What’s the best approach here considering I’ll be running LT headers?.... http://i65.tinypic.com/2z56lqd.jpg http://i67.tinypic.com/ilhfyr.jpg http://i67.tinypic.com/24wwrad.jpg |
Re: Need help with engine mounts/perches
Just use the stock perches.
|
Re: Need help with engine mounts/perches
Quote:
http://i64.tinypic.com/2e5phxz.jpg http://i65.tinypic.com/ao6p7b.jpg |
Re: Need help with engine mounts/perches
I just installed my L92 on my frame and used the POL engine perches. They fit well. Had to enlongate one hole on driver side and grind just a tiny bit in the frame edge so the holes line up. What I did was, leave perch bolts loose and the slowly torque them down until they fit flush.
|
All times are GMT -4. The time now is 07:56 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com