I need some help with polyurethane trailing arm bushings
1 Attachment(s)
I made a rough drawing of the dimensions. The doughnut that completes the bushing doesn't slip over to the point where it's flush. Its stop is a step in the main body of the bushing, but it sticks out somewhere between .090 and .100
Here's the question: is there mistake with the bushing, with the anti squat bracket, or are they just incompatible? |
Re: I need some help with polyurethane trailing arm bushings
4 Attachment(s)
I ran into that problem with my stock brackets. I had to shave down the bushing to make it fit.
|
Re: I need some help with polyurethane trailing arm bushings
how did yours end up working?
|
Re: I need some help with polyurethane trailing arm bushings
This is a difficult part for me to rate. I replaced the original bushings because they were old and dry-rotted. Functionally, they still seemed to be working alright. I installed the new ones about two years ago, and I haven't really thought about them since.
|
All times are GMT -4. The time now is 10:01 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com