[bagged81]

Here is a question. It may be stupid, but I am going to ask it anyway, haha. I am not sure how similar out trucks are but my bumper is level with the bottom of my rocker panel. Right now, I have 3" spindles and a 4.5" Z on my frame sitting in my garage and the bumper is 1/2" off the ground and the rocker will sit flat. If I wanted to cut the rockers off (red area) so that the doors layed on the ground, then what do I do about the bumper area (circled with ?)? Would I have to cut say 3.5" (height of the rocker) off the bottom of the bumper? Did you run into this?