The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Rokcrln · 03-05-2007, 08:09 AM

I found it very easy to do them while they wer still bolted to the head board, floor and while the floor was bolted to the frame. If they were not bolted down I would think you will have some problems. Between the head board, wheel tubs and rear posts it makes for a very solid system so cutting it all loose could move around a bit. Good luck.

Kevin
LFD Inc.

03-05-2007, 08:09 AM	#216
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: LFD's low buck truck build! I found it very easy to do them while they wer still bolted to the head board, floor and while the floor was bolted to the frame. If they were not bolted down I would think you will have some problems. Between the head board, wheel tubs and rear posts it makes for a very solid system so cutting it all loose could move around a bit. Good luck. Kevin LFD Inc.