Re: Cross Member Drop?
I set the rack so the links are parallel to the pivot points on the lower control arms adn lower BJ's. When the LCA's are flat the rack is flat. It's actually very simlar to where the factory steering links were located in relation to the crossmember. You have to remember how high my crossmemebr is compared to your dropmember. Your LCA bushings are still below frame bottoms. Mine are actually above the bottom of the frame rails. I sectioned 1.5" out of the bottom of the rails for LCA clearance, therefore mine loks much higher.
Edit: I retract my previous statement, my LCA bushings actually are still below the frame rails just a little. I set the rack parallel so I think bumpsteer will be taken care of. Only time will tell.
Last edited by HotRodYJ; 01-23-2008 at 11:55 PM.
|