Quote:
Originally Posted by HotRodYJ
The circumference of the tube OD is just over 4", therefore there is about four linear inchs of weld on each end of the tube. And I might add the tubes were properly prepped and beveled so there is much more weld there than you can actually see. FULL penitration is a must for strengh . And thank you very much for the compliment.
|
I'm not trying to rain on anyones parade. I'm also doing a chopped member on my burb but if it was my rig i wouldn't trust just that little bit holding it all together. I'v have bone stock 6cyl's shear bolts in factory mounts. I'm going with DIY4X's set up. using a poly bushing in a factory style set up but all 1/4" plate. Even a simply gusset would double your strength on that mount.