Re: Yukon Jack or other intelligent people-need advise
Quote:
Originally Posted by Big J
What if you did a bit of forming with the OL' Hammer? You only need a 1/8th to a 1/4". With a dead blow or wooden hammer it shouldn't damage the oil pan. I wouldn't think it would, lol. Might let someone else chime in if you consider this route.... Just a thought.
|
Have you tried to take an oil pan off yet What a PITA, dun it once and that was two many.Lots of stuff has to come off , including the crossmember, but I'm not putting you down for your idea, I need them all. But, I have considered your thought somewhat, I was going to raise the engine and put something between the oil pan and the cross member, letting the wieght of the engine squish it a little. Seems a bit drastic. I hope you haven't taken this the wrong way, as I value your thoughts and time
I was just over on the '73 side and no luck, I'll have to post up a WTB
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
|