[Yukon Jack]

The K20 puked it's upper input shaft bearings after getting low on gear oil - the Rockwell transfer cases are notorious for that and I screwed up and didn't check my leaky transfer case before it got to low. I usually add some every 5-6 months and just got lazy this time. Anyway, it's transfer case will be replaced with an NP205 and while I'm at it, I'm going to move the motor forward a bit so I can get the body lift down to a more friendly 2" and for good measure I will also slap in a Dana 60 front axle that I bought in December of 2006.