Re: Dropmember Rear 63-72 Spy Pic
Lookin' good! 'Bout time
Quote:
Originally Posted by SCOTI
Nice!
On a side note..... I attempted to slide the LSx into the truck tonight. Using some plates that have been scribed w/the typical 'LS to sbc' mount orientation, the drivetrain is pretty close. The 4l80e required removing more of the trans tunnel than I had hoped & I'm thinking I might need to get a f-body oil pan for better bottom end clearance for servicing entrance/exit.
It's a good thing these motors don't have distibutors @ the back of the manifold. The fit is tighter than my wallet .....
|
So, you're using an off the shelf adapter plate instead of the PB plates? I would definitely recommend the F-body pan; from test fits in the Blazer, I would say it is a necessity.
__________________
-Chris
Instagram _elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy
|