I only had a few hours this morning to work on the rocker. I have the upper section done and ready for final smoothing but I had to section the rocker and add a new lower half. It was about 1/4" to short so the ends did not line up with the body. I took a second rocker and ripped the the lower half off it and lined it up the the rocker bottom edge and made sure the side curves lined up with the body how it should be. Then I sliced through the two rockers and removed the bottom half of the top rocker and tacked the new lower into place. Sunday I will finish it up, prep it and weld it in so I can start on the door.
Kevin
LFD Inc.