The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 67-72 Bolt in pedal assembly

Rokcrln · 10-16-2008, 08:22 PM

Well my stock pedal is 17 1/4" from kick panel to CL of pedal arm. I am going to say yours is about 19" +- because the stock pedal is centered over the frame and yours needs to clear the frame since it is mounted to the side of it. Is their any way to have an offset arm just as it goes above the frame in the compressed position or would that require a larger floor opening? I guess you could just add an offset pedal pad or a larger pedal mount that would allow it to be closer to the factory location. I am doing a drive by wire 5.3L an was looking forward to mounting it over to the left about 1" more than stock for added driving comfort.

Kevin
LFD Inc.

10-16-2008, 08:22 PM	#79
Rokcrln Senior Member Join Date: Jul 2005 Location: Winters Ca. 95694 Posts: 4,843	Re: 67-72 Bolt in pedal assembly Well my stock pedal is 17 1/4" from kick panel to CL of pedal arm. I am going to say yours is about 19" +- because the stock pedal is centered over the frame and yours needs to clear the frame since it is mounted to the side of it. Is their any way to have an offset arm just as it goes above the frame in the compressed position or would that require a larger floor opening? I guess you could just add an offset pedal pad or a larger pedal mount that would allow it to be closer to the factory location. I am doing a drive by wire 5.3L an was looking forward to mounting it over to the left about 1" more than stock for added driving comfort. Kevin LFD Inc.