The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - HOW TO: Replace Interior and Exterior Door Handles (1997 Yukon GT)

**lks dcvn** · 10-31-2008, 03:55 PM

Step 3. With the surround removed - pry the switch in the door up - it is connect with pressure seals - if you get a screwdriver under it and push up - they will pop out as you go around the edge of it. Leave the switches connected to the wiring - since you will have to put the window down in a little bit.

Step 4. Remove the two screws in the door handle - here they are starting to come out.

10-31-2008, 03:55 PM	#3
lks dcvn Registered User Join Date: Jan 2007 Location: Columbus, Ohio Posts: 4,346	Re: HOW TO: Replace Interior and Exterior Door Handles (1997 Yukon GT) - with pix Step 3. With the surround removed - pry the switch in the door up - it is connect with pressure seals - if you get a screwdriver under it and push up - they will pop out as you go around the edge of it. Leave the switches connected to the wiring - since you will have to put the window down in a little bit. Step 4. Remove the two screws in the door handle - here they are starting to come out. Attached Images