The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

71'tahoe · 12-17-2008, 11:03 PM

Hey pugs! Looking good. You any good with a welder? I have seen a lot of s-10 guys do a stock floor body drop by welding 2x3 from the front frame horns,behind the rear control arm mounts,to the end of the bed.You could just run it flat from the control arm mount straight back to get the flat frame rails like the factory truck were,then you could keep the floor of the bed almost factory.Just a thought?!

12-17-2008, 11:03 PM	#63
71'tahoe Registered User Join Date: Feb 2004 Location: lynchburg ohio Posts: 736	Re: 57 build Hey pugs! Looking good. You any good with a welder? I have seen a lot of s-10 guys do a stock floor body drop by welding 2x3 from the front frame horns,behind the rear control arm mounts,to the end of the bed.You could just run it flat from the control arm mount straight back to get the flat frame rails like the factory truck were,then you could keep the floor of the bed almost factory.Just a thought?!