[Chuck78]

After reading the thread through start to finish again, I noted that you said your bracket uses none of the existing holes. The red one Jake uses says that the lower right hole only partially aligns, and you will need to drill this one out. This hole, other than the slight elongation in the frame, is common between the two boxes on their kit. Where is yours in relation to this? The inside the frame pic you have looks like the holes were welded shut? Can't seem to place the old locations.

I think I may give your kit a shot, but still thinking about the 60-62 CPP kit. Need to make sure I have a complete grasp on everything before I save almost half off and buy yours. Any input to help me along?