Installed the bags in the rear and
finally sat the burb on the ground! It looks awesome... the pics don't do it justice.
Total drop in front is 4 1/2" and 6" in the rear. I was able to transfer in/out OK but getting the chair in/out was tough so I'll order drop spindles to lower the front another 2". Removing the bump stop brackets (bump stops are already in the trash) will get me another 2" approximately in the rear. I might also remove the running boards to get the chair a couple of inches closer to the seat...
Bags assembled and ready for install.
After installing the passenger bag I noticed the top of the mounting stud was hitting the floor so I pulled it and removed 2" from the stud
Off the jack stands
Still have a lot of work to complete : mount the tanks, compressors, valves, run the lines, shorten the rear sway bar end links, install, drop spindles, etc...