The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

ol Curt · 06-25-2009, 05:42 PM

I just cut me a piece to fit over it. Cut out the areas for the radio and knob holes, painted it and bolted it up using the radio hardware. It seems to look ok and is functional.

I'll post a couple pics when I get home....oh here i found one at work. I had a piece of scrap metal. I suppose you could epoxy the piece on as well. It is thin enough it doesn't show too bad.

06-25-2009, 05:42 PM	#5
ol Curt Junior Member Join Date: Dec 2006 Location: Newburgh, IN Posts: 1,247	Re: Radio/dash question I just cut me a piece to fit over it. Cut out the areas for the radio and knob holes, painted it and bolted it up using the radio hardware. It seems to look ok and is functional. I'll post a couple pics when I get home....oh here i found one at work. I had a piece of scrap metal. I suppose you could epoxy the piece on as well. It is thin enough it doesn't show too bad. Attached Images __________________ 1966 Chevy C10 Longbed I'm Bob....ol Curt was my Grandpa The truck was his and he sure as heck wouldn't understand why I took a perfectly good truck and tore it down! Last edited by ol Curt; 06-25-2009 at 05:44 PM.