[69trk]

Well i canceled my order with jet hot because of hooker not producing any headers. I received my money back and ordered a set through summit and received them today. This is what i should of done to begin with... Anyways, on the passengerside, one of the primary's hits my front crossmember. Should i grind the crossmember down or dimple the header? It doesn't need much at all. I already moved the motor back as far as i could without redrilling my motor mounts. I'll install the other side tomorrow. I tried to install it today, but ran out of patience. Looks like i'm going to have to remove the oil filter to allow me enough room to swing them in there. Once i have these things fitting, i'm going to take them to jet hot here in okc and have them coated. They said that they will give me a pretty good discount. Also, it looks like i'm going to have to replace my transmission crossmember with a tubular one.. Has anyone else had to do this? Also what one do you guys recommend?