The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Marv D · 07-26-2009, 11:13 AM

I am not a bigblock guy at all, but if that is for the pair of bare castings, that is still pretty cheap! However, if it's not the ultimate head that you want,, it's a waste. As far s what flows better,, if neiher have been on a flow bench,, it's a guess. I've seen "tons of work" not help sbc heads one bit (in fact hurt low lift volocity and flow so bad it makes them useless for anything other than WFO at the track) and I've seen it turn them into some really sweet heads. So again were back to the flow bench.

07-26-2009, 11:13 AM	#2
Marv D Registered Truck Offender Join Date: May 2008 Location: hells training ground (aka Ariz) Posts: 3,118	Re: 077 aluminum heads I am not a bigblock guy at all, but if that is for the pair of bare castings, that is still pretty cheap! However, if it's not the ultimate head that you want,, it's a waste. As far s what flows better,, if neiher have been on a flow bench,, it's a guess. I've seen "tons of work" not help sbc heads one bit (in fact hurt low lift volocity and flow so bad it makes them useless for anything other than WFO at the track) and I've seen it turn them into some really sweet heads. So again were back to the flow bench. __________________ Still playin with trucks, even at my age! When you're dead, it's only a problem for the people around you, because you don't know you're dead. .....It's kinda the same when your STUPID. I just did my taxes and reviewed my SS statement. Thanks to the current administration it looks like I will only have to work till noon on the day of my funeral.