Quote:
Originally Posted by porterbuilt
I have some input for finding the center-line without having to install/remove the bed.
Just take a measurement from a bed mounting hole to the center of the rear inner wheel tub... transfer this measurement to the chassis using the corresponding bed mount's hole. You will have some room to adjust the bed fore and aft... but not more than 3/8" or so.
|
Thanks, I've been pulling measurements to make sure my air tank compressors, etc will clear crossmembers and the wheel tubs, etc...but didn't think about doing that in this instance...guess that's why you get paid the big bucks
