Quote:
Originally Posted by Dahawk
How did you get your floor to align and did you put your front pillar patch over your old one or did you cut it out and replace it
|
I had actually replaced all the lower sheet metal, once I started digging there was nothing that could be saved. So I had to remove and replace all of the sheet on the pillar and the footwell panel.
As far as the floor aligning it fit in nice once I had trimmed about 1/8" off the front flange the full length of the floor. That got it flush with the firewall and as far as centering it fell right in with the A pillars being there. I had talked to EBfab and he suggested putting the A pillars in first to help guide the floor in. The only thing is you want o make sure if you have to replace your pillars that you take lots of measurements and get them back in to were the originals were. If you have any other question or need help let me know.