The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

69c10stepside · 02-19-2010, 07:45 PM

Got the truck in the shop today, was able to work on it a good solid four hours before having to stop to get ready to go eat with the family. Pulled hood front clip and have all of the wires unhooked on the engine. Did some minor cleanup on the front frame horns and some other areas while I was talking on the phone.. Going to wirebrush everything after the motor is out. Spent time cleaning the floor of all of the dirt, grime, and junk that fell out of the front clip when I took it off. It is amazing the amount of stuff I swept up today.

If I have the time tomorrow (which I think I do), I will pull the motor.

:edit:

Also found that I need to swap out the steering sector.. what a better time to do it eh?

02-19-2010, 07:45 PM	#13
69c10stepside Large Member Join Date: Jun 2002 Location: Northwest Arkansas Posts: 747	Re: '89 GMC C1500 build thread Got the truck in the shop today, was able to work on it a good solid four hours before having to stop to get ready to go eat with the family. Pulled hood front clip and have all of the wires unhooked on the engine. Did some minor cleanup on the front frame horns and some other areas while I was talking on the phone.. Going to wirebrush everything after the motor is out. Spent time cleaning the floor of all of the dirt, grime, and junk that fell out of the front clip when I took it off. It is amazing the amount of stuff I swept up today. If I have the time tomorrow (which I think I do), I will pull the motor. :edit: Also found that I need to swap out the steering sector.. what a better time to do it eh? __________________ 1989 GMC C1500 ECSB 1972 Gmc Jimmy 1972 Chevy C10 SWB Sold Last edited by 69c10stepside; 02-19-2010 at 07:53 PM.