Quote:
Originally Posted by Ipaintgrt
I read in your posts that you are sanding the epoxy primer. That does suck sanding that. If you need to sand it you can wet sand it with some grease and wax remover and some wet or dry sand paper. If your going to just prime over it you could just scotchbrite it. or recoat and apply a primer over it. Keep up the good work. Scott
|
Thanks for the tip. I was just sanding the places where it had runs to flatten them out before any other coats went on. It worked. I'll be using the epoxy primer as a base only and covering with a more sand friendly primer later.
I didn't really plan on any welding repairs from here on out. I thought I would stick with the body adhesive where it was needed. I know it can be done, but I might find a gas bottle for my welder and give another try. The door repairs have thrown me a curve. The flux core just has too much spatter and heat to mess with on a long straight seam like the door.