Quote:
Originally Posted by MrBeast
I was going to ask, did you rebuild the NV4500 yourself?
|
Yes, there is a pic or two in here somewhere.
Quote:
Originally Posted by MrBeast
I have a good question for you, I have heard that the stock GM master cylinder is not sufficiant to push the dodge slave on the cummins, I am looking at a wilwood that has a 1" bore and 1" stroke, do you think that would be sufficiant?
|
I honestly do not know. I have a complete hydraulic system for a 1st gen Dodge in mine. Might be something to consider for simplicity and ease of adapting.
Speaking of adapting, how are you adapting your 4500 to the 1st gen plate on the back of the motor?? Did you get the '94up motor plate with the trans?? If not you will need a conversion bellhousing to mate the 4500 to a 1st gen plate and at that point I would highly suggest the 1st gen hydraulic setup.
__________________
1972 K20 Suburban, 5.9L Cummins, Banks Power Pack, NV4500HD, NP205, H.A.D., D60/14FF ARB
Link To Build: HERE.