Re: HEI Ignition Problem
ok guys
i plulled the #1 plug to find tdc i rotated the motor over by hand untill the timing mark and taimimg tab lined up on 0 degrees i stuck a screwdrive i the hole and its hitting the piston so thats good
the only thing is the rotor is sitting/facing 180 degerees from ware it should be (between 3 and 6 post on cap)
if i take it out and rotate it will be in between 1 and 2 so my question is will it drop right back in if i just pull it out and rotate 180
__________________
1970 2wd 3/4 ton- 2004 crate 350 thorley tri-y headers-edelbrock performer eps manifold 600cfm performer carb, crane cams energizer cam,lifters, dual 2.5 magnaflows, mallory HEI, powermaster 140 amp altenator, griffen aluminum radiator.(8 MPG )
|